Factory Reset

1. Unlock and open door
2. Hold [REG] button for 5 seconds
3. Enter 1470852369 + *
4. Close door and allow the unit to lock and set the bolt direction.

*The Master PIN will now be set to 1234. Please change your Master PIN*

Delete a User PIN, Keytag, Sticker or Card

1. Unlock and open door
2. Press [REG] button
3. Enter Master PIN + *
4. Press 3 + *
5. Press 3 + *
6. Enter User number to delete (1~70) + *
7. Repeat from Step 6 or press [REG] to quit.

Keytag, Sticker or Card registration

1. Unlock and open door
2. Press [REG] button
3. Enter Master PIN + *
4. Press 3 + *
5. Press 1 + *
6. Enter User number (1~70) + *
7. Hold the Keytag to CARD on the keypad
8. Repeat from Step 6 or press [REG] to quit.

User PIN code registration

1. Unlock and open door
2. Press [REG] button
3. Enter Master PIN + *
4. Press 3 + *
5. Press 1 + *
6. Enter User number (1~70) + *
7. Enter desired User PIN code
8. Repeat from Step 6 or press [REG] to quit.

Change Master PIN code

1. Unlock and open door
2. Press [REG] button
3. Enter current Master PIN + *
4. Press 1 + *
5. Enter NEW (4~10 digit) Master PIN + *
6. Press [REG] to exit

*If you are unable to change the master PIN. Please perform a Factory Reset*

The SHP-DS510 requires a 35mm to 55mm thick door, and with a minimum of a 90mm lock stile which is the measurements from the edge of the door to any detail or glasswork.

1. When installing this door lock, please make sure that you first find out whether your door is a right-handed or left-handed door. Looking from the outside, if the hinges on your door are on the right, your door is a right-handed door.
2. Make sure you’ve installed the magnetic sensor in the right port. Sensor port A for right handed doors and sensor port B for left handed doors.